Gipsolep

  • Interior

Sorry, this entry is only available in American English, Polish, German, French, European Spanish, Romanian, Irish, Български, Dutch, Slovenščina and Österreichisches Deutsch. For the sake of viewer convenience, the content is shown below in this site default language. You may click one of the links to switch the site language to another available language.

APPLICATION: GIPSOLEP is the glue intended for cementing gypsum tiles and other facings in closed spaces. It is characterised by very good adhesion and creates a firm joint. It is especially recommended for gluing the gypsum tiles STEGU.

PREPARATION OF THE BASE: GIPSOLEP can be applied to any firm base such as: concrete, brick, silicate blocks, and plates made from cardboard and gypsum. The base must be clean and dry, and grounded, if necessary.

PREPARATION OF THE GLUE: The glue should be tempered in a clean bucket (free from any old glue residue which would cause quicker binding). Pour the glue into water (5 kg of glue to 1,6-1,9 litres of water) and mix it accurately by hand or by means of a mixer. Mix it again after approx. 2 min. The glue should be used up in 45 minutes.

GLUING: Spread the glue point-wise on the tiles edges (to a thickness of approx. 5 mm) and while pressing a tile against a wall remove the excessive glue which could obstruct joint pointing.

TOOLS: Clean bucket, mixer, and spatula for spreading the glue.

RECOMMENDATIONS: Before gluing it is necessary to perform tests in order to eliminate any unforeseen problems which could appear during the whole operation of gluing.

TECHNICAL DATA:
Efficiency: to 3,5 m2 per container.
Mixing time: approx. 2 min.
Mixing proportion: 1,6-1,9 litres of water to 5 kg of glue
Ambient temperature: 5°C – 25°C
Consumption of glue: 3 kg for 1 m2, at the average
Time of consumption: up to 45 min.
Time of preliminary binding: 8 hours
Total time of binding: 5 days

The glue is not water-resistant and frostproof.